...
5-Estimate how much thread will be needed for each hole (station), wax : I’ve been measuring out 1 inch per page (count both covers too). You will need three threads. Wax the threads, then and thread your three curved needles. Straight needles can be used, but they make this binding a little harder.
...
6-Lay down the cover, holes towards you. (I like to set the remaining pages on end, so I simply have to flip them down to the table top without worrying about getting them out of order.) Set up for binding: best done at the edge of a table or desk, with remaining pages nearby stacked in order.
7-Start with the top or bottom covercover, holes towards you, at the edge of a table. From the inside, put the needle through the first hole in cover, to the outside (bottom) of cover; tighten the threads (gently), and tie the threads together into a knot close to the inner hole. I usually tie 1-2 more knots in the same place, for extra security. Repeat this step next 2 stations.
...